An interactive extrusion output calculator. Adjust a product cross-section, explore line speed and see the theoretical material balance change in real time.
Move the geometry, choose a material-density starting point and see the nominal mass balance respond. Fine-tune any value with the labelled controls.
For a hollow section: A = π × (OD² − ID²) ÷ 4, with ID = OD − 2 × wall. With A in mm² and density in kg/m³: kg/m = A × density ÷ 1,000,000. Then kg/h = kg/m × m/min × 60. This describes theoretical material balance, not extruder or downstream capacity.
For project-specific advice, contact ARKPM or email [email protected].
Develop a pipe production line around specified dimensions and resin grades, coordinating tooling, sizing, cooling, haul-off and finishing with your product mix, site conditions and agreed acceptance criteria.
Explore this line
Translate a profile drawing into a custom equipment brief, with section-specific tooling, cooling support, haul-off and cutting planned around critical dimensions, visible surfaces and the intended production mix.
Explore this line
Specify tubing production equipment around bore, wall and resin requirements, with material preparation, sizing, cooling and take-up coordinated for the tube dimensions and delivery format your application needs.
Explore this lineBring the calculation together with your drawing, resin grade and acceptance requirements for an equipment review.
Discuss your extrusion line
